 |
| The L-6000 is a
hand operated rivet-nut header tool for use with the following rivet-nut
thread sizes: 4-40, 6-32, 8-32, 10-32, 10-24, 12-24, ¼-20, and ¼-28.
Metric sizes: M3, M4, M5, and M6. |
| Operating
Instructions: |
(Refer to Fig. 1) Pull knob (A) completely out and place rivet-nut onto
pull-up stud. Holding rivet-nut with fingers, push knob until it is all
the way into the barrel (B). Rivet-nut should now have all the threads
engaged onto the pull-up stud. Hold tool at a 90-degree angle to work
properly, and place rivet-nut in hole. Squeeze handle (C) toward barrel
(B) until resistance is felt. The handle will not touch the barrel. DO
NOT apply excessive force or threads may be stripped. Release handle (C)
and pull knob (A) completely out, this will release pull-up stud from
rivet-nut. |
| |
| Replacing Broken
or Damage Pull-Up Studs: |
- Unscrew anvil
sleeve L-28 and remove. L
- Loosen 3 set
screws, L-5 using the access hole with hex key (included), by
rotating knob to expose set screws
- Loosen 2 set
screws at access hole located below L-32 on barrel; again rotate
knob.
- Unscrew pull-up
stud by holding it firmly in place, a vise may be necessary to hold
the pull-up stud. Turn entire tool counter clockwise to remove from
coupling, L-20.
- Replace pull-up
stud by reversing instructions. DO NOT DAMAGE OR SCAR PULL-UP
STUD, THIS WILL PREVENT SMOOTH OPERATION WHILE STUD ROTATES IN
ADJUSTABLE ANVIL, L-29.
NOTE: If replacing pull-up stud with a different thread size,
it requires changing adjustable anvil, L-29; collar, L-15, and in
some cases; the coupling, L-20.
 |
| Oiling: |
| A drop of oil at
set screw openings on the barrel will keep the tool operating smoothly. |
Back to Atlas
|
|
